|
|
|
|
|
#1
07-29-2005, 09:21 PM
|
|||
|
|||
|
how do i put the head back on
1988 300e 6 cylinder gas..
103 engine I think.... i have reworked the head and i am ready to reinstall.... i have the bolt pattern and i know about cleaning the holes... 1. how do i tighten...? do i hand tighten then put the torq wrench on the number one bolt and tighten all the way or just snug down... 2. Do i tighten the bolts buy number all the way and then move on to the next? 3. after i hit the right torque numbers do i go an additional half turn? 4. what are the right torque numbers? 
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 87 300e with water in the oil | blueranger | Tech Help | 21 | 07-29-2005 10:22 PM |
| !New to Mercedes, how do I put my Automatic Back on? | ASR13 | Diesel Discussion | 3 | 05-27-2005 11:21 AM |
| 300e Molding fell off, how do I put it back on? | john90290 | Tech Help | 1 | 05-22-2003 02:47 PM |
| a couple of questions on head removal | MarkM | Diesel Discussion | 14 | 02-13-2002 11:43 AM |
| Head gasket replacement | MarkM | Diesel Discussion | 16 | 11-02-2001 12:07 PM |
Threaded Mode
