|
|
|
|
|
#1
08-23-2005, 09:31 PM
|
|||
|
|||
|
Clutch slave cylinder piston projectile
Because the tolerances were so tight, I had to disconnect my clutch slave cylinder from my transmission to bleed it. All was well until my clutch slave cylinder piston turned into a projectile.
How do I get the piston back into the slave? It is very stubborn and doesnt want to go back in. I am not fighting any hydraulic pressure in this process. Do I have to put it in a vice and force the piston back in? I want to avoid damaging the rubber boot obviously. Thanks, Brian 82' 300TD Wagon w/ Getrag 5 speed 
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| clutch cylinder | drradon | Tech Help | 3 | 04-22-2005 04:14 AM |
| 240d clutch slave cyl. | von sponyiak | Diesel Discussion | 0 | 03-07-2005 10:07 AM |
| Need help! my Clutch is locked up!?!? | dieseldiehard | Vintage Mercedes Forum | 17 | 12-18-2004 05:26 PM |
| 190e-16 slave cylinder | beamonk | Tech Help | 1 | 08-20-2000 09:21 PM |
| Clutch: How do I stuff the Slave Cylinder back in? | Cinnaman | Tech Help | 1 | 10-19-1999 08:14 PM |
Threaded Mode
