|
|
|
|
|
#1
09-05-2005, 01:35 AM
|
|||
|
|||
|
Timing Marks Don't Line Up
Hello, I'm replacing the timing chain on my '88 300e and the timing marks don't line up. The key in the crank is straight up and down but the mark on the cam is off to the left (a little arrow pointing towards a small hole). As y'all can tell, I'm sorta new at this but I'm gonna be good!
Should I turn the crank alone to make the new chain match the sprockets exactly and leave the cam timing mark alone? Should I turn the camshaft so that the timing mark is straight up and down? Any help would be greatly appreciated. 
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Camshaft & Injektor Pump Timing: | Doktor Bert | Diesel Discussion | 17 | 11-09-2008 09:00 PM |
| V-8 cam tower timing marks | dloveless | Tech Help | 7 | 01-26-2004 09:56 AM |
| C220 timing marks | keronpa | Tech Help | 0 | 05-11-2003 08:15 AM |
| 260e Timing Marks | COMPAQ | Tech Help | 4 | 02-22-2003 12:36 PM |
| You CAN replace oil cooler line without removing the motor mount. | GregS | Diesel Discussion | 13 | 02-12-2003 12:29 AM |
Threaded Mode
