|
|
|
|
|
#2
02-12-2001, 06:13 PM
|
|||
|
|||
|
Unfortunately the EHA is usually what leaks. The o-rings usually aren't the problem (unless you leave them out).
I looked at the code table and 4 is for the airflow potentiometer. The device isn't sold separate from the airmeter housing. It should be tested to verify the problem. The device has a three wire connector that should have 5v, ground and the control signal. The control signal should be .5-.9v at idle and go up toward five volts.
__________________
Steve Brotherton Continental Imports Gainesville FL Bosch Master, ASE Master, L1 33 years MB technician 
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Check engine light on 94 E420 and a couple of other questions | screedchan | Tech Help | 31 | 03-24-2006 02:55 PM |
| 420 SEL - Check Engine Light Codes Needed. | rsamson830 | Tech Help | 1 | 10-30-2001 07:34 PM |
| Fuel Trim? OBDII duty cycle, CHECK ENGINE ? | ke6dcj | Mercedes-Benz Performance Paddock | 1 | 08-07-2001 10:21 PM |
| Fuel Trim? OBDII cycle and CHECK ENGINE ? | ke6dcj | Tech Help | 1 | 08-06-2001 08:54 AM |
| check engine light came on after extremely rough idling! | apprentice | Tech Help | 8 | 07-09-2001 08:02 PM |
Threaded Mode
