|
|
|
|
|
#1
06-29-2001, 01:25 PM
|
||||
|
||||
|
Way back when, another member here inquired about the complexity of changing engine mounts on a 380SEL. Benzmac indicated this was a tough diyer job and that he used "special tools". I haven't fully explored what all is involved, but at this point I know I'll need a good 6mm allen head socket on the passenger side mount. The one closest to the engine has limited access and it appears an L-shaped allen-head will be needed there.
Other than quality tools(Hazet-Stahlwille-Snap-On), do I need anything else? Thanks for your time.
__________________
Mike Murrell 1991 300-SEL - Model 126 M103 - SOHC "Fräulein" 
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| timing chain - upper guide rails.. ? special tools | rsmcmahon | Tech Help | 3 | 01-25-2010 12:00 PM |
| Help! Engine Dead???? | Breckman99 | Diesel Discussion | 17 | 05-10-2005 12:26 AM |
| W124 Engine Mount Cooling Tube modification TSB?? | d2bernhard | Tech Help | 1 | 09-08-2004 09:24 AM |
| How to get Access to the Driver's Side Engine Mount on 190E 2.3-16??? | JimSmith | Tech Help | 4 | 11-27-2001 11:57 PM |
| 1982 240D Engine Mount Changeout Help | JimSmith | Diesel Discussion | 7 | 08-13-2001 11:52 AM |
Threaded Mode
