![]() |
|
|
|
#4
|
|||
|
|||
Hi,
Here is some more information, that most likely rules out the ignition clutch. When the car fails to start, there is current going to the spark plugs, meaning the rotor is turning. Also accidently, I found out that if I depress the gas pedal all the way and then crank the engine, it starts right away. So far this technique has worked all the time (atleast 10 times). Also right before the car is going to stop, if I press the gas pedal, only the indicator that shows fuel economy on the dash moves, but the rpm does not change. After it stops, as usual, if I keep cranking without depressing the gas pedal the car does not come on. As soon as I press the gas pedal, has to be all the way in, the car comes on right away. Have not tried to replace the OVP yet. Any clues ? Thanks in advance. Saumil
__________________
Saumil S. Patel |
Bookmarks |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
16V - hard start | Prime16 | Tech Help | 5 | 01-03-2005 12:20 PM |
88 260e Hard Start...Too Rich | bountyhunter | Tech Help | 8 | 12-27-2004 01:43 PM |
W124 E320 no start - pulled neutral safety switch - what do you think? | 71Rcode | Tech Help | 21 | 11-24-2004 07:04 AM |
Where to begin ? Car doesn't start (doesn't turn over) | renyf1 | Tech Help | 23 | 06-22-2004 11:29 AM |
Sequence to start a M104 | atamians | Tech Help | 1 | 01-17-2003 04:26 PM |