|
|
|
|
|
#1
10-09-2001, 05:03 PM
|
|||
|
|||
a/c push button control w126
I have a problem which I believe is in the pbc (push button control) on my automatic control unit
The fan wont work sometimes, but if I lower the round temp to min it works, only to not work when set to a temp. After moving the temp switch up and down and pushing the buttons and adjusting the fan setting from high to low and back to automatic I can get it to work on auto agian. I have read the DYI section which describes the problem in the early 126, with poor connection between the temp control switch and also poor soldering points. My question is if I pull the pbc out where and how do I start to improve the connections. Thankyou Mark 
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Yet another A/C Climate Control Problem for 190/201 | orangedawg | Tech Help | 3 | 12-16-2003 08:10 PM |
| R129 500SL Climate Control Auto Mode and A/C longevity | warren128 | Tech Help | 2 | 12-09-2003 02:32 PM |
| Where is a/c control unit? | lakelover | Tech Help | 5 | 11-01-2003 10:05 AM |
| Push botton climate control blues | Old Deis | Diesel Discussion | 8 | 10-20-2003 09:27 PM |
| acc push button module (3rd version) | erubin | Diesel Discussion | 5 | 06-11-2003 08:04 PM |
Threaded Mode
