|
|
|
|
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
W126: proper joint connection between front upper control arm and sway bar
Just to check and make sure:
Just to asuage my nervousness that during my front shocks' installation the upper control arm was not properly reconnected to the ball joint at the sway bar ends, could someone please describe the proper configuration of the joint: i.e., proper bushings, spacers, bolts. I just don't trust some people who've worked on my vehicle, recently. Sometimes their ignorance of the model shows - and this area could be critical. Thanks. If someone has a good photo or drawing of the area, that would be even more appreciated. |
#2
|
||||
|
||||
I can't help you 'til I get home, but there's no call to touch any suspension parts other than the shocks when replacing shocks.
Sixto 91 300SE 81 300SD |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
DIY page. Introduction to Upper Control Arm Rebuild | BoostnBenz | Diesel Discussion | 0 | 02-16-2004 12:05 AM |
92 300D 2.5 front control arm bushings help | NickMendoza | Diesel Discussion | 1 | 11-29-2003 12:00 PM |
Replaced Upper Control Arm Bushings and Sway Bar Bushings | mholbrook | Diesel Discussion | 2 | 09-23-2003 07:44 PM |
Week off, $2,500 and lessons learned!!! (long! | Mike T | Mercedes-Benz SL Discussion Forum | 1 | 04-04-2003 01:18 PM |
Front Suspension Question W123 | Gray Market Survivor | Tech Help | 5 | 08-22-2001 10:28 PM |