Quote:
Originally Posted by Army
Question 2
Is there a special tool - a partially circular socket (like two half moons facing each other) - available for undoing the nut inside on the other end of the pulley shaft to release the inner bits?
Any help will be greatly appreciated (before I just install the secondhand replacement I got and hope for the best!)
|
There really is a tool specifically made to remove these - I THINK it's a SIR tool - I bought it ($80!) but I don't know if it is still available. It makes this job pretty simple. The pulley is stamped and very easy to damage. The tool is a bolt pulling back on two pretty tough steel half-circles captive in a metal shell.
07-25-2010, 09:44 PM
Threaded Mode
