|
|
|
#1
|
|||
|
|||
Where on the exhaust does the support go from the tranny?
Quick question, on my 1988 300E where does the support that bolts from the tranny to the exhaust go. Does it go on the straight section or does it go to the area that goes at an angle to more of the centre of the car? Does anyone have a picture? When I bought the car, the bracket was in the trunk and it looks bent. Any help would be appreciated.
Thanks, Steve
__________________
1997 E320 1990 Nissan 300ZX Twin Turbo (Stage X+) |
#2
|
||||
|
||||
Can't say about the support on the 300E's, but every other one I have seen has been straight. So, it should mount to the exhaust in line with where it mounts to the tranny. I would highly suggest, if the support looks bent, get a new one. Also get a bushing kit for the support mount, the kit is only about $15.00, includes new rubbers, bolts, washers and U-bolt.
__________________
Mike Tangas '73 280SEL 4.5 (9/72)- RIP Only 8,173 units built from 5/71 thru 11/72 '02 CLK320 Cabriolet - wifey's mid-life crisis 2012 VW Jetta Sportwagon TDI...at least its a diesel Non illegitemae carborundum. |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Tranny Quest (722.) Please Help. | DaveL | Tech Help | 4 | 10-25-2004 09:34 PM |
Intake, Exhaust Manifold available -300d cali model | adamb | Diesel Discussion | 2 | 10-12-2003 09:23 PM |
Broken Exhaust Clamp W210 | DaveJ | Tech Help | 2 | 10-02-2003 02:20 PM |
74 230/4 -exhaust from the oil cap? | theoAtVecna | Tech Help | 9 | 04-26-2002 12:25 AM |
oHH PLEASE HELP. TRANNY! | StephenG | Tech Help | 2 | 10-15-2000 11:20 AM |