|
|
|
#1
|
|||
|
|||
93 300E Headlamp door removal
Trying to remove my faded headlamp doors on my 93 300e , came across a new set , started looking at it today , but looks different from my 190 , no thumbwheels for the turnsignal removal, or like the 190 2 bolts that hold the assy in
if anybody has done this , please advise i would appreciate it . still love this forum , a great service to all mb owners !! thank you
__________________
1985 190 2.3 1993 300e 2.8 |
#2
|
|||
|
|||
Pressing a plastic tab on the back of the
turn signal (which is attached to a clip) releases the signal assy. When released, the turn signal assy will slide straight forward. Look on the driver's side where there is more room to explore with a flashlight. It might help to loosen the exposed fasteners on the headlight assy if the signal assy is stuck. The headlight assy is held in place by a plastic locating pin on top, a hex screw on the inboard side, and two hex screws on the outboard side that are hidden by the turn signal assy. The narrow body panel below the light is attached to the headlight on the inboard side and the fender body panel on the outboard side. You must remove the screw from the inboard side of the body panel. You may only need to loosen the screw on the outboard side of the body panel, but be careful not to bend the panel when removing or replacing the headlight assy. I cannot tell you anything about the headlight wipers, if you have them. I do not. Best of luck. Darrell |
#3
|
|||
|
|||
Thanks very much , will give it a shot this weekend , the darn plastic is very brittle from what im seeing already , tried taking the fog light removal panel off yesterday darn tab broke right off gonna have to keep the epoxy handy i can see already
john
__________________
1985 190 2.3 1993 300e 2.8 |
#4
|
|||
|
|||
If you have wipers, be careful when removing the panel under the headlight - you'll pull on a few hoses and they may break...
You'll also need to remove the wiper arm (8mm nut) before removing the panel. andre 90 300e 02 ml320 |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Rebadging '87 300e | emr0591 | Detailing and Interior | 6 | 09-04-2007 09:12 AM |
'86 300E vs '91 300E... Any opinions out there??? | pjtib | Tech Help | 23 | 05-04-2005 09:26 PM |
300E FIRST-gear start | brewtoo | Tech Help | 16 | 03-11-2005 05:27 PM |
*CLEAN* W124 Gray MB-Tex Front Seats / 300E 260D 300D (300E 2.8) and (W124 Wagons) | FA22 | Mercedes-Benz Used Parts For Sale & Wanted | 5 | 03-01-2004 08:40 PM |
Transmission Question 1988 300E (Need Technical help)n | china beach | Tech Help | 4 | 03-26-2002 10:25 AM |