Had a good clunk especially when turning or on certain bumps in the road. Even at low speed. Found torsion bar support broken into parts, it wiggled when I grabbed it. Simple fix, about $8 for Uro part from the Rock. And of course, I noticed now a bushing is wobbling about. Should have ordered those at the same time....

Attached Thumbnails

     

__________________
91 300 TE 235K
93 Cabriolet 155K sold
92 300 TE 200K boneyard

yeh ...kind of scary when that bracket breaks... i have replaced a couple of them on two different 124's.... that brackets isn't the most stout of pieces.

also as you know that's easy rubber to replace

__________________
1989 300ce 129k
( facelifted front,updated tail lights, lowered suspension,bilstein sports, lorinser front spoiler, MOMO steering wheel, remus exhaust,stainless steel brake lines). (Gone)

1997 s320 154k (what a ride). Sold with 179k miles. Replaced with Hyundai Equus

1994 e320 Cabriolet 108k



1972 280se 4.5 153k Owned for 12 yrs, sorry I sold it


[/SIGPIC]

Guyton, in case you haven't read the thread about URO door seals check it out. The general consensus is URO parts are "inferior" to be polite. You may be better off getting used replacement OEM torsion bar brackets from a MB vehicle at a local salvage yard.

__________________
Fred Hoelzle

+1

Both of my URO brackets broke within six months of installation. Went to pick and pull to get used original OEM brackets!

__________________


1989 300E

2005 Acura TL

2011 Hyundai Elantra Limited

Swing hard! Take chances!