Hi All,

I have acquired a Mercedes 450 slc which has been in storage for 15 years.

Now i am busy with the renewal of the oils.

As far as the engine oil is concerned, it was very thick and sludgy. Drained it. Then added some fresh oil and cranked the engine to check if oil is flowing throught he cam oil feeder tubes.

All looked ok , and the cam followers and hydraulic lifters look visibly in working condition.

I have good oil pressure during swinging of the engine.

Before i fire the engine, i wish to know if it is recommended to remove the hydraulic lifters, press out the old oil and soak it in new oil for a few days before installing.

Any thoughts on this, or should i leave well alone and fire the engine.

Your comment will be appreciated.

C