Quote:
Originally Posted by Diseasel300
Since this is a serpentine belt setup, grab your various pulleys and tensioners and see if there is any "slop" in the shafts. If there is, it can cause the pulley to be very slightly out of alignment when the belt is tensioned. The result is usually squealing or chirping. Tight/stiff pulleys due to failing bearings are another frequent cause of squeals on a serpentine setup, you're looking for something that's causing drag.
|
the belt does sit a little close to the outside edge of the tensioner pulley.
I'll take a pic and post.
I think I got that pulley just off the shelf at local parts place(commercial place not pep boys).
If I can find the old pulley should I put it back on? I bought that one from Pelican in January 2014?
10-20-2017, 12:44 PM
Threaded Mode
