![]() |
|
|
|
#1
|
|||
|
|||
Hi , I have the following problem
Cold start idle speed is initially about 500RPM (car nearly stalls). It then increases gradually to about 1300RPM after 5 minutes. It then stays too high for about the next 20 minutes when it will gradually slow down to about 600RPM. The car used to run very rich for about 2-3 minutes after a cold start so I adjusted the arm in the Warm-Up Regulator to stop this. The car has no O2 sensor (it is Australian). I have the factory manuals and wonder if the problems I have above are due to the Warm-Up regulator ? I have checked the auxilary air valve and it seems to open and close correctly. The Bosch authorised dealers in Sydney tell me that you cannot adjust the Warm-Up regulator (but I know that you can). Any idea what I should do ? thanks Doug McCutchan W126 1983 280SE |
Bookmarks |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
1983 240D valve adjustment.. | Plantman | Diesel Discussion | 6 | 02-28-2004 03:33 PM |
1983 300D Steering box Adjustment Procedure | Victor1 | Diesel Discussion | 1 | 01-06-2004 02:32 PM |
280SE 1983 idle speed adjustment | Bob_Holbert | Tech Help | 0 | 03-14-2003 09:08 PM |
Valve adjustment on M110 280SEL | Ben300SD | Tech Help | 3 | 06-01-2002 05:26 PM |