|
|
|
|
|
#1
10-06-1999, 01:34 AM
|
|||
|
|||
|
I performed the check of the lambda as per
benzmac instructions.(lambda you can check) my readings were as follows.25 low 31 high avg of 28. Should I start with an adjustment of the lambda or change the o2 sensor and check again? this car has 103000 on it and I dont know if the o2 sens was ever been changed. Also what size of wrench is needed for the o2 sens? I only go to 19mm at this time. Thanks again Paul 92 300TE 4MATIC |
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| The evil lamda control | S-Class Guru | Tech Help | 2 | 11-13-2003 06:09 PM |
| Is it possible to adjust Lamda without a duty cycle meter??? | jay3000 | Tech Help | 2 | 01-02-2003 02:07 PM |
| 87 300E runs rough at idle & low speeds, lamda sensor? | Mateo | Tech Help | 3 | 09-29-2002 05:31 AM |
| Lamda Tower? O2 Sensor? Which is it? | MikeF | Tech Help | 5 | 10-26-2001 09:09 AM |
| Lamda adjusting | Josie's Dad | Tech Help | 4 | 11-24-2000 09:57 PM |
Threaded Mode
