|
|
|
|
|
#1
02-06-2005, 06:03 AM
|
||||
|
||||
Zebrano veneer separating from heat control panel
I have a problem with the veneer Zebrano curling away from the aluminum backing for it in the Heater control panel in the dash.
What is the best way of flattening the veneer and re-attaching it? I have tried searching, but "reattaching Zebrano" does not work and I am stumped to find a search term which does work. Regards, Tony
__________________
Tony from West Oz. Fatmobile 3 84 300D 295kkm Silver grey/Blue int. 2 tank WVO - Recipient of TurboDesel engine. Josephine '82 300D 390kkm White/Palamino int. Elizabeth '81 280E, sporting a '79 300D engine. Lucille '87 W124 300D non-turbo 6 cylinder OM603, Pearl Grey with light grey interior Various parts cars including 280E, 230C & 300D in various states of disassembly. Last edited by TonyFromWestOz; 02-06-2005 at 06:38 AM. 
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Climate Control Panel Removal, 88 300SE | Leewolf | Tech Help | 0 | 07-17-2004 12:49 PM |
| Keeping heat control in on position upon startup.. | KylePavao | Diesel Discussion | 3 | 11-12-2002 11:31 PM |
| New AC Servo and Amp, Still Full Heat | Elripster | Tech Help | 2 | 11-27-2001 09:35 PM |
| New AC servo and amp, still full heat | Elripster | Diesel Discussion | 0 | 11-26-2001 08:38 PM |
| AC charge, heat control and Oil LIne Change | MBZflyer | Tech Help | 8 | 05-02-2000 09:59 AM |
Threaded Mode
