There seems to be some confusion when I have read different instructions on assembly the SLS valve - I had a problem with clearance when I bolted the valve body back together such that the cam was pinched and would not budge. I notice that when I examine the groove that the big bearing rides in, off to the side near the access hole there is an indent that the bearing could sit in, but if this is the case, the bearing would be off center and not make contact with the tiny spring, it would however allow the piston to move further down the bore and allow for more clearance so that cam would not be pinched. On the other hand, it is sensical that the bearing would sit on the end of the tiny spring and center in the groove (not in the indent)which is how I had it the first time . . what's up? I need the SLS valve expert here, thanks!

best -James