Quote:
Originally Posted by JB3
so rummaging around, I found the 4-speed shifter out of my 115, which had the endcap looking like this-
looks like I need to order this above specific piece, and probably 115 267 22 50 which holds the other side of the spring.
Is there no bracket to hold the back side of this plastic piece? I don't remember one, but then again I grabbed this shifter through mail and converted an automatic, so its possible im missing some bracket that went with the shifter assembly |
I just got the cap today, it came with no washer. I used the one out of the old cap. Here is where I am confused. Do I push the cap into the hole over the spring? Reason Im asking is the lip of the cap will become inverted and I assume this is by design to keep the cap in place once it has been inserted. I'm asking as I have just read a "caveman post" and did not want to messup my new cap. Thanks in advance.
Did you happen to measure the clip retainer you made? If so I would sure like the measurements, so I can get one made.
12-30-2013, 09:44 PM
Threaded Mode
