Last night found I had no blower and CCU did not seem to do anything (no clicks, that I could hear)

Checked all fuses, esp 14 & 8. All good.
Checked blower resistor connector. Good

About to go dig further:
- See if there is 12V from pin 2 of resistor plug to ground with defrost on.
- Check at blower itself if there is power to motor? Try 12v to motor.

Some questions:

- Ground G102 - anyone know just where that is?
- For blower to run, does engine have to be running. That is, which position should key be in?
- On **************, Kent says a vacuum problem could prevent blower from running? Anyone know more?

I need to locate the blower wiring diagram. I had it, but can't now find it on the on-line Startek manual or on my old CD That's the one that shows the resistor and it's pin numbers) OK, found it again. Page 303 has resistor plug. Thinking 12v pin 2 & ground and blower should run?

https://www.dropbox.com/s/mbe6wvc73n1c26b/Blower%20wiring%20and%20other%20diagrams%2083_acc.pdf?dl=1

__________________
Graham
85 300D,72 350SL, 98 E320, Outback 2.5