Howdy all! I'm a newbie here, but I'm not new to MB vehicle ownership and maintenance.

I have a problem with an '06 320cdi and I'm hoping that someone here might be able to steer me in the right direction... The car will crank over, but will not start. This is what my scanner is showing me (among other things that I think are not related to the no start issue)...

https://photos.google.com/photo/AF1QipOMg77U88iVFmBaH8LKxrsbiniIQmx2jutY1JeO I'm sorry, but I can't figure out how to get the photo to display here.

Does the N3/9 have to sync with the N73 in order for the car to start? If so, how would one go about fixing the problem?

Any help would be sincerely appreciated!

The link does not work for me. What does the code say?

__________________
Jim

It says"Synchronization of Control Modules N73 (EIS [EZS] Control Unit) And N3/9 (CDI Control Unit) Is Being Performed = NO"

X2 link does not work

__________________
92 e300d2.5t
01 e320
05 cdi
85 chev c10

I'm sorry guys. I'm trying to figure out how to post pictures on this platform. I'm apologize for the inconvenience. I know that you are trying to help me and I'm not making it very easy. I'm not computer illiterate, but this forum is somewhat different than others when it comes to posting pictures is suppose.



https://ibb.co/xKbZcD9Y

https://ibb.co/xKbZcD9Y

Oops yes must have posted at about the same time. I'm away from my reference material but I seem to recall n3/9 being on the can B bus and n73 on can C bus. So the Can be to c bus interface may be the issue? It's located under the steering column remove the panel clean the connections. But like I say I'm not close to my reference material you may like to look at the can bus maps to verify if my memory is any good.

__________________
92 e300d2.5t
01 e320
05 cdi
85 chev c10