See Crankshaft Position Sensor DIY

ok, are we talking about an item that has about 4 wires coming into it, and maybe 2 going out? it's not connected to the engine.

Fyi......

__________________
Steve Danville
what i did myself.
CPS
rear shocks
MAS x 3.
SparkPlugs (twice)
Fuel pump & Filter
Window switch
replaced both failed horns with Honda horns.
Cleaned ERG Tube
Oil changes
Oil consumption Fix
Brake Pads
A/C Recharge
Anti-Freeze change X 2.
Front Shocks. Monroe. $90
Mercedes Warrenty Work:
Harmonic balancer,power steering clamp. Cat converters.Drive Shaft Bearing.s
Replaced Outer Lower Tie Rods and front lower ball joints at 156,000 miles

No, the sensor is attached to the top of the bell housing (reads off of the teeth on the flywheel) it's behind the drivers side cylinder head, very hard to see it, have to try to look or feel between the head and firewall. Has 1 connector, I think 3 wires, not sure, and has 1 screw retaining it to the bell housing. It fits inside a bore, aimed towards the ring gear.

Gilly

__________________
Click here to see the items I have up for auction at EBay

Click here to see a photo album of my '62 Sprite Project Moneypit (Now Sold)