Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   PeachParts Mercedes-Benz Forum > Search Forums
Reload this Page Search Results
Register ShopForum Gallery FAQ Calendar Today's Posts Search

Page 1 of 3 1 23
Showing results 1 to 30 of 61
Search took 0.01 seconds. Search: Posts Made By: Jim Herold
Forum: ML, GL, G-Wagen, R-Class, Unimog, Sprinter 07-19-2017, 08:16 PM
Replies: 1
Views: 1,704
Posted By Jim Herold
1999 ML430--which brand(s) water pump has a reputation for reliability?

I need to replace the water pump on my 1999 ML430. One brand that is sold by almost every on line MBZ parts supplier is Graf. I have found contradictory information about Graf water pumps--eg made...
Forum: ML, GL, G-Wagen, R-Class, Unimog, Sprinter 12-01-2014, 09:45 PM
Replies: 1
Views: 2,740
Posted By Jim Herold
After starting this thread and getting no replies...

After starting this thread and getting no replies I continued to look for the answer to my question. The answer is in the attached pdf.

I followed the instructions and easily removed my mirror. ...
Forum: ML, GL, G-Wagen, R-Class, Unimog, Sprinter 11-22-2014, 08:50 PM
Replies: 1
Views: 2,740
Posted By Jim Herold
1999 ML 430--How do I remove the rear view mirror?

What are the steps to remove the rear view mirror on my 1999 ML430? Attached is a picture showing the mirror mount to the windshield.

Thank you very much,

Jim
Forum: ML, GL, G-Wagen, R-Class, Unimog, Sprinter 07-21-2014, 12:07 PM
Replies: 2
Views: 1,195
Posted By Jim Herold
Do you know the reason why the short side goes to...

Do you know the reason why the short side goes to the front? As I look at the inside of the air box, the bottom of the box slopes but is basically flat. I can't figure out why the filter is...
Forum: ML, GL, G-Wagen, R-Class, Unimog, Sprinter 07-15-2014, 03:39 PM
Replies: 2
Views: 1,195
Posted By Jim Herold
Correct Orientation for Installing ML430 Engine Air Filter?

What is the correct orientation for the engine air filter on a 1999 ML430?

The filter pleats are "stepped" with a long and short section. The pleats obviously install facing down. But is the...
Forum: ML, GL, G-Wagen, R-Class, Unimog, Sprinter 03-31-2013, 02:52 PM
Replies: 5
Views: 2,740
Posted By Jim Herold
1999 Ml 430--Using impact wrench to remove steering wheel nut

I need to replace the combination switch (turn signal switch) on my 1999 ML430. I've read how difficult it can be to loosen the steering wheel hold down bolt.

I have access to an 18.8V impact...
Forum: ML, GL, G-Wagen, R-Class, Unimog, Sprinter 07-09-2011, 11:25 AM
Replies: 2
Views: 3,008
Posted By Jim Herold
1999 ML430 Sunroof Wind Deflector popping out

Previously I had to replace the wind deflector assembly because of a broken plastic "tab" that pushed through the end of the right side spring arm . As a result, there was nothing to hold the...
Forum: ML, GL, G-Wagen, R-Class, Unimog, Sprinter 07-06-2011, 05:34 PM
Replies: 2
Views: 3,008
Posted By Jim Herold
1999 ML430 Sunroof Wind Deflector popping out

Each time we open the sunroof and the wind deflector pops up, the deflector itself pops loose from the two pivot points on the front underside of the sun roof opening that are designed to hold the...
Forum: ML, GL, G-Wagen, R-Class, Unimog, Sprinter 01-14-2011, 02:40 PM
Replies: 3
Views: 2,296
Posted By Jim Herold
Yes, the Torque Converter does have a drain plug....

Yes, the Torque Converter does have a drain plug.

Is the magnetic patch an MBZ part or a generic auto store item? Is there a preferred placement spot or just wherever it fits without...
Forum: ML, GL, G-Wagen, R-Class, Unimog, Sprinter 01-13-2011, 03:36 PM
Replies: 3
Views: 2,296
Posted By Jim Herold
1999 ML430 ATF change--ATF hot or cool?

Should ATF be changed hot or cool?

Some instructions for changing ATF say to first bring the transmission fluid to operating temperature. Other instructions say to change ATF while it's cool. ...
Forum: Tech Help 12-05-2010, 11:00 PM
Replies: 7
Views: 3,504
Posted By Jim Herold
I have always used Mobil 1 15-50 with a change...

I have always used Mobil 1 15-50 with a change interval of never more than 7500 miles. The car uses less than 1 qt of oil between oil changes. I have never had to add oil between changes.
Forum: Tech Help 12-05-2010, 06:41 PM
Replies: 7
Views: 3,504
Posted By Jim Herold
My Cats carried a 2yr. 25K warranty. Since Jan 1,...

My Cats carried a 2yr. 25K warranty. Since Jan 1, 2009, Cats in Calif must be CARB (Calif Air Resources Board) approved for the vehicle and model and carry a 5 yr. 50K warranty. Up to this point, my...
Forum: Tech Help 12-05-2010, 03:42 PM
Replies: 7
Views: 3,504
Posted By Jim Herold
Short life expectancy of aftermarket Catalytic Converters

I have a 1987 190E 16v. I need to replace an aftermarket catalytic converter that has failed with only 1500 miles of use. The "biscuit" or "cookie" inside the converter can be heard rattling. This...
Forum: Tech Help 11-23-2009, 09:26 PM
Replies: 8
Views: 3,500
Posted By Jim Herold
190E 16V Hot Start ("Hot Soak") Problem

I my ran the engine at idle for 30 minutes and it showed a steady 5.8 bar of fuel pressure. With the engine off, pressure dropped to approximately 2.7 bar and held steady at that level for over an...
Forum: Tech Help 11-16-2009, 11:40 AM
Replies: 8
Views: 3,500
Posted By Jim Herold
190E 16V Hot Start ("Hot Soak") Problem

I have not connected my tester to confirm that the fuel pressure bleeds off.

Do I simply disconnect the cold start valve at the fuel distributor and put my tester in line? Then do I run the...
Forum: Tech Help 11-15-2009, 01:37 PM
Replies: 8
Views: 3,500
Posted By Jim Herold
190E 16V Hot Start ("Hot Soak") Problem

I removed removed the hose from the accumulator and ran the engine. A very minor amount of fuel was seeping from the accumulator so I replaced it with a new Bosch unit.

This did not fix my...
Forum: Tech Help 11-01-2009, 08:14 PM
Replies: 8
Views: 3,500
Posted By Jim Herold
190E 16V Hot Start ("Hot Soak") Problem

My 1987 190E 16V exhibits classic hot start ("hot soak") symptoms according to what I read and copied from a post elsewhere in this ShopForum:

Engine cold - no problem starting
Engine warm but...
Forum: ML, GL, G-Wagen, R-Class, Unimog, Sprinter 07-26-2009, 10:02 PM
Replies: 5
Views: 10,700
Posted By Jim Herold
Here is an update to my own thread: 1. I...

Here is an update to my own thread:

1. I accidentally found a new OEM replacement trailer wiring harness. It fits an unbelieveably wide range of vehicles, but is supposedly plug 'n play for...
Forum: ML, GL, G-Wagen, R-Class, Unimog, Sprinter 06-20-2009, 01:25 PM
Replies: 5
Views: 10,700
Posted By Jim Herold
Wiring 1999 ML 430 Trailer Lights

Every dealer I checked advised that the factory trailer light wiring harness is no longer available for the 1999 ML 430.

1.) Does anyone know a source for a new or used factory plug-in harness?
...
Forum: Tech Help 06-11-2009, 01:45 PM
Replies: 8
Views: 13,309
Posted By Jim Herold
Fuchs Titan 4134 ATF backwards compatibility

Is it advisable (or even preferable) to do a AT fluid change on a 1999 ML 430 with the 722.6 transmission using Fuchs Titan 4134 ATF developed for the 722.9 transmission? This would result in mixing...
Forum: ML, GL, G-Wagen, R-Class, Unimog, Sprinter 02-23-2009, 10:07 PM
Replies: 9
Views: 4,854
Posted By Jim Herold
I purchased my '99 ML 430 new and, as you...

I purchased my '99 ML 430 new and, as you described, it was equipped without fog bulbs and without associated programming. I live in Calif but regularly drive the Oregon Coast. I wanted fog lights...
Forum: ML, GL, G-Wagen, R-Class, Unimog, Sprinter 02-23-2009, 06:29 PM
Replies: 2
Views: 1,968
Posted By Jim Herold
I was able to get information from a number of...

I was able to get information from a number of people on and off this site, which I very much appreciate. To return the favors and maybe help someone else, here is my report on a completed job:
...
Forum: ML, GL, G-Wagen, R-Class, Unimog, Sprinter 02-23-2009, 05:49 PM
Replies: 1
Views: 1,089
Posted By Jim Herold
How many liters required for an ATF change?

My vehicle is a 199 ML 430:

I plan to change the fluid in the torque converter and transmission. I have an early series VIN# for a ML 430 and there are two rubber "covers" in the bottom of the...
Forum: ML, GL, G-Wagen, R-Class, Unimog, Sprinter 02-23-2009, 05:33 PM
Replies: 0
Views: 1,006
Posted By Jim Herold
Trick to replacing AT shifter bushing?

My vehicle is a 1999 ML 430:

I need to replace the (lost) shifter bushing where the shift lever passes through the hole on the upper part of the transmission shifter arm. I have the MBZ bushing. ...
Forum: ML, GL, G-Wagen, R-Class, Unimog, Sprinter 02-05-2009, 03:29 PM
Replies: 2
Views: 1,968
Posted By Jim Herold
ML 430-Questions about replacing A/T cooler hoses

I need to replace the automatic transmission cooler hoses on my ’99 ML 430. Questions:

1.) With the engine off, are the hoses pressurized?
2.) Will I loose more ATF fluid than what is in the...
Forum: ML, GL, G-Wagen, R-Class, Unimog, Sprinter 12-01-2008, 01:38 AM
Replies: 12
Views: 5,738
Posted By Jim Herold
Background: I absolutely believe in keeping my...

Background: I absolutely believe in keeping my vehicles in perfect condition with the best parts. However, this is one project that I decided just wasn't worth the effort. It's a lot of work to...
Forum: Mercedes-Benz Performance Paddock 05-15-2008, 07:44 PM
Replies: 1
Views: 2,297
Posted By Jim Herold
Remote starter hookup 1987 190E 16V?

What is the correct way to hookup a remote starter switch?

I think Step 1 is to disconnect the EZL plug connection with the heavy green wire from the ignition control module. Have I got this...
Forum: Tech Help 02-21-2008, 11:50 AM
Replies: 6
Views: 2,211
Posted By Jim Herold
Thank you both for the responses. I would...

Thank you both for the responses. I would normally check both the tensioner and chain condition myself and repair whatever is necessary. I'm not in a position to do this now so I am anticipating...
Forum: Tech Help 02-20-2008, 05:17 PM
Replies: 6
Views: 2,211
Posted By Jim Herold
190E 16V timing chain rattle

I have a 1987 190E 16V with 167,824 miles . Approximately 11K miles ago, at 156,199, I installed the upgraded timing chain tensioner because I was getting timing chain rattle after starting a hot...
Forum: ML, GL, G-Wagen, R-Class, Unimog, Sprinter 05-22-2007, 09:56 PM
Replies: 12
Views: 5,738
Posted By Jim Herold
I will try Goop Marine. Interesting suggestion. ...

I will try Goop Marine. Interesting suggestion. I am the one who started this thread. I talked off line with several manufacturers in the paint/solvent business. Their suggestion was to check...
Showing results 1 to 30 of 61
Page 1 of 3 1 23

 
Forum Jump


All times are GMT -4. The time now is 02:42 AM.

Contact Us - Mercedes-Benz Discussion Forum - Archive - Privacy Statement - Terms of Service - Top

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page