Ok I was getting code P0715 and the transmission was going into limp mode. So I replaced the Conductor Plate. Now I get code P0743 and the car is once again in limp mode with the MIL on. I had the codes cleared from the ETC, but it instantly resets the same code. When I was replaceing the conductor plate I had trouble removing the PWM solenoid valve and had to use a pair of pliers to gently remove it from the valvebody. I suspect that it was damaged when I removed it and is cuasing the trouble code I am getting. Can anyone confirm this for me? I have ordered it and plan to install it tomorrow, but was wondering if anyone else has had a similiar problem and could point me in the proper direction is this isn't the cuase.