Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   PeachParts Mercedes-Benz Forum > Mercedes-Benz Tech Information and Support > Tech Help

Reply
 
LinkBack Thread Tools Display Modes
  #1  
Old 11-23-2004, 11:02 AM
crash dummie
Guest
 
Posts: n/a
power window question

i have a 1996 e320, and the pass back window seemed to come off track. i can hear the motor run, when i push the window button. my best bet is to pull the door panel off, but i have not done this on this vehicle. is there anything special i need to do, or a special tool i may need?

thanks in advance.

Aaron

Reply With Quote
  #2  
Old 11-23-2004, 11:07 AM
nglitz's Avatar
Registered User
 
Join Date: Aug 2004
Location: Hamilton Square NJ, near Trenton
Posts: 391
No special tools, just be careful to get all the screws, etc loose. If the panels on a '96 are like those on my '87, the panel is held on with plastic hooks. After the screws are out, the panel slides upwards, disengaging the hooks and the window trim.

Best of luck,
__________________
Norm in NJ
Next oil change at 230,000miles
Reply With Quote
  #3  
Old 11-24-2004, 12:15 AM
Registered User
 
Join Date: Jan 2000
Location: Kuala Lumpur, Malaysia
Posts: 10
The new model just use clip like japanese cars.
Reply With Quote
  #4  
Old 11-26-2004, 10:57 AM
crash dummie
Guest
 
Posts: n/a
it looks like the wire is all goofed up, and i will need to buy the whole regulator assembely.
Reply With Quote
  #5  
Old 11-26-2004, 12:35 PM
Registered User
 
Join Date: Feb 2002
Location: n.e. georgia
Posts: 73
rear window

Hello crash,
This is a common problem on these cars.The reg is easy to replace. Drill out the rivets and replace the part with new m-b rivets, will need a large rivet gun, the part is around 100 dollars.
It comes with or with out the motor. no need for a new motor. The best way to avoid this happening on the other windows is to open and close them every few weeks. If you look you will see that most likely one of the plastic wheels broke.
Fastlane has the parts for less than 100. Dan
Reply With Quote
  #6  
Old 11-28-2004, 07:40 PM
Registered User
 
Join Date: Jan 2000
Location: Kuala Lumpur, Malaysia
Posts: 10
That's right. The regulator is not repairable. You need to replace with new one. I just use the normal rivets from hardware store. Make sure the size is right.
Thanks
Ali
Reply With Quote
  #7  
Old 11-28-2004, 10:46 PM
Registered User
 
Join Date: Apr 2003
Location: Richardson, TX
Posts: 92
I just replaced one of my rear window regulators with the help of this forum. Regarding the rivets, I used the MB steel ones. I bought a large, two-handed rivet gun at Harbor Freight for around $12. It popped those rivets with ease.
__________________
1998 E320 120K mi
1991 Miata 80K mi
2001 Ranger 109K mi
Reply With Quote
  #8  
Old 11-29-2004, 07:56 AM
crash dummie
Guest
 
Posts: n/a
Quote:
Originally Posted by oldfatman7
Hello crash,
This is a common problem on these cars.The reg is easy to replace. Drill out the rivets and replace the part with new m-b rivets, will need a large rivet gun, the part is around 100 dollars.
It comes with or with out the motor. no need for a new motor. The best way to avoid this happening on the other windows is to open and close them every few weeks. If you look you will see that most likely one of the plastic wheels broke.
Fastlane has the parts for less than 100. Dan
maybe i am looking at the wrong parts, because the regulator i looked at was anywhere from $204-250... i will look again..this is for the pass rear window, the only parts i had seen were with a motor. i dont know if they sell it without a motor.

it looks like the wire goofed up in there somewhere, and the plastic wire guide woreout. i disconnected the power to prevent it from coming down, now i just have to find the part as cheap as possible.

Last edited by crash dummie; 11-29-2004 at 08:27 AM.
Reply With Quote
  #9  
Old 11-29-2004, 10:04 PM
Registered User
 
Join Date: Apr 2003
Location: Richardson, TX
Posts: 92
On FastLane, regulator without the motor shows up for my '98 at $97. Call Phil for the right part.
__________________
1998 E320 120K mi
1991 Miata 80K mi
2001 Ranger 109K mi
Reply With Quote
  #10  
Old 11-30-2004, 04:34 PM
crash dummie
Guest
 
Posts: n/a
Quote:
Originally Posted by benzthere
On FastLane, regulator without the motor shows up for my '98 at $97. Call Phil for the right part.
i talked to phil and he said i can get it without hte motor for less than $100...

is this as simple as unbolting the old motor and bolting up the new motor?

Cheers

Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are On
Pingbacks are On
Refbacks are On




All times are GMT -4. The time now is 02:43 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page