![]() |
|
|
|
#1
|
|||
|
|||
1992 W140 S500 brake handle
I broke my brake handle. Can it be easily change? Where do I start?
|
#2
|
||||
|
||||
Can you provide a bit more information? Are you talking about the emergency release handle mounted in the dash on the left? Did the plastic handle break or did the release cable itself break?
The more information you provide, the better folks here can help you.
__________________
KenP 1996 S500 W140 Coupe |
#3
|
|||
|
|||
It is the emergency release handle mounted in the dash on the left? Yes the plastic handle break.
|
#4
|
||||
|
||||
See the attached. Looks to me like you may luck out as that is listed as a separate part. If you can't remove it directly, you probably have to remove the lower dash panel to gain access where it attaches to the release cable.
__________________
KenP 1996 S500 W140 Coupe |
#5
|
|||
|
|||
Thank you for your assistance. Will try to dismantle the handle.
I could not remove the lower dash to gain access to the release handle. Where do I start? Last edited by everlyne; 01-20-2005 at 10:44 PM. |
#6
|
|||
|
|||
Fixing a 210.
I recently purchased a 6 set of CDs for a E300 210. I've made the installation which does not down load the CDs to my hard drive. You are directed to install 1 of 4 depending on what info you need. They were purchased from Manuals Unlimited online and cost $83 shipped. I have not been able to find much details on "how to" such as removing the instrument panel or removing the injectors. I may not be using the system right as it is tricky to navigate.
Anybody had expierence with this set?. Carl |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|