|
|
|
|
|
#1
03-06-2005, 08:18 PM
|
|||
|
|||
|
Pitman Arm Removal (450SE)
To get to the steering box seals, I need to take off the Pitman arm from the box.
Can I simply pull that end w/ a Pitman Arm puller, or do I have to take off the tie rod end? I am not changing the Pitman Arm, only want to free it from the steering box. Is there enough play in the suspension to get it off only at the box end? 
|
|
#2
03-06-2005, 09:35 PM
|
|||
|
|||
|
I think you can leave them on, but off the top of my head am not 100% sure.
Where do you live? I bought the centering screw for the steering box and can let you use it for a small fee. Note: this was for my 115 which had a steering box with a 116 part number so it will work.
__________________
63 220S W111 76 300D W115 2013 VW JSW TDI M6 previously- 73 280 SEL 4.5 86 300E 5 speed 2010 VW Jetta TDI M6
|
 |
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Steering Gear seal leaking at pitman arm shaft | rsmcmahon | Tech Help | 2 | 10-19-2004 11:57 PM |
| Turning the Pitman Arm / Steering Linkage | 300SDog | Diesel Discussion | 6 | 04-28-2003 12:08 PM |
| Removal of Rocker Arm | Daddysparky | Tech Help | 4 | 02-16-2003 10:20 PM |
| 123 300D wiper arm removal | Bear | Diesel Discussion | 3 | 02-11-2002 08:58 PM |
| Pitman arm, Idler arm, tie rods, ball joints on w123 | David | Tech Help | 4 | 08-21-1999 01:40 AM |
Linear Mode
