|
|
|
|
|
#1
04-10-2005, 01:49 PM
|
||||
|
||||
new problem on the 104 motor (?) timing gear bolts came off
Has anyone had this problem?The car died while driving. Found that the intake cam was not turning.The bolts that hold it to the cam had unscrewed themselves
 . The chain or gear did not fall out.it was held in by the upper timing cover  . I checked the exhaust cam and only one bolt was tight.Today I put the chain back on to see how many valves are bent. Lucky the intake valves are involved,they are much cheaper 12.50 v 45.50 dollarsJust wondering if this has happened to other members Thanks Rich 
__________________
88 300E White, sold 9-04  88 190E Black 2.3 sold 90 300CE White, Grey sold 12-24-04  92 400E White,Grey Sold 5-06  90 300CE 91K Signal Red,Black Sold 2007 1989 300CE Smoke silver,Tan Sold 1-08 1993 300E 3.2 M104 motor 1991 300CE White,Grey 1994 E420 beautiful car,gone to new home 1994 E320 Smoke an Parchment.Beautiful car 
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 1992 300CE W124 Doorlock Problem | Ashman | Tech Help | 10 | 07-31-2004 10:37 PM |
| Please, please, please help! 87 300SDL Trans Problem | pstutcher | Diesel Discussion | 2 | 07-21-2004 10:54 PM |
| 420 SEC 1st gear problem | Rémy | Tech Help | 1 | 07-02-2001 08:30 PM |
| Starter / Ring Gear Problem? | igolf2 | Tech Help | 1 | 07-24-2000 05:49 PM |
| 91, MB 560 SEC Gear Shift Problem | Vance | Tech Help | 2 | 05-21-2000 11:47 AM |
Threaded Mode
