Hey,
That J-1801 Spring compressor being sold on e-bay is made by a company called J.T.C. manufactured in the USA.
Has anyone had success using this tool?

Danny

__________________
1984 300SD Turbo Diesel 150,000 miles

OBK member #23

(\__/)
(='.'=) This is Bunny. Copy and paste bunny into your
(")_(") signature to help him gain world domination

all of the tools pictured are in correct, the one mercedes uses is about a 2 foot similar to an all thread bolt, that really doesn't compress the spring, but rather clamps it, holds it in place, then after removing the bolts at the lower control arm bushings, allows you to release the spring tension by loosening the nut on the tool, if anyone wants a picture of the unit send me an email, i will gladly send it, or post it here

Yes, Please post the picture of the tool to this site. Do you know where the tool can be obtained?

Steve

Replaced bushings, but cannot get spring back in. Klann type tool didn't work. No access for tool. Tried to position with floor jack, but its most trial and error to get alignment. Probably need pit lift or proper spring tool (p/n 107 589 03 31 00) but don't know where to find it.

here is the picture of the tool mercedes has to remove the spring