While I have the subframe off to replace all the bushings, links, mounts, etc., I need to replace the driveshaft boots and relube the CV joints. When I got to the point of loosening the bolts that attach the halfshafts to the diff, I found that the allen wrench I thought would fit didn't. It was getting dark, however, and I couldn't see the area well enough to tell what type of bit it takes for sure. I think there were closely spaced internal splines, so could this be a XZN type fastener? (is that the same as a triple-square?) Anyone know what type and size bit to use on this and who might carry it?

Thanks,

Gary

Gary:

If the triple sqaures are what you need, Lisle Tools makes a set that is carried at a lot of Pep Boys. If you have Car Quest parts stores in your area, they carry the Lisle line, but under their name. Their part numbers for Lisle tools are the same as Lisle.

Here's a photo of the Lisle Tools triple squares.

http://www.lislecorp.com/tool_detail.cfm?detail=1080

__________________
Mike Murrell
1991 300-SEL - Model 126
M103 - SOHC
"Fräulein"

Should be 10mm triple-squares. Autozone has a set that includes that size.

__________________
1990 190e 2.6 - The only one I can really call "My Car".

1987 190e 2.3 - The donor car's up and running, only mods are Euros and a Sony headunit. My Dad's runabout now.

1990 300e 2.6 - The parents' ride.