I drove my car and checked the codes immediately after my car has low power and poor idle. Needs help.
Please see attached codes on each module. Open connection problem? fuse?
Any suggestions to repair my car?

Diagnostic Module N59—No Faults in System

LH-SFI Module (N3/1)
code 4 Voltage at hot wire MAF sensor (B2/2) insufficient or too high, or open
circuit in ground wire at hot wire MAF sensor


Distributor Ignition N1/3-No Faults in System

Base Module N16/1
code 10 Base module (N16/1) voltage supply output fuse F2 open circuit
code 11 Base module (N16/1) voltage supply output fuse F3 open circuit
code 12 Base module (N16/1) voltage supply output fuse F1 open circuit
code 13 Base module (N16/1) voltage supply output fuse F4 open circuit

ABS w/ASR Control module (N30/1)
code30 CAN data line to EA/CC/ISC module (N4/1)

EA/CC/ISC Module (N4/1)
code 9 Left rear axle vehicle speed sensor (L6/3) from ABS/ASR control
module (N30/1)

SRS Control module (N2/2)3 Driver airbag squib (R12/3)
code 4 Front passenger airbag squib (R12/8)
code 8 Voltage supply
code 9 SRS warning lamp (A1e15) or insufficient time to read out the DTC
memory or erase DTCs

My car is a 1993 500SEL, W140 with M119 engine.

Thanks in advance.