|
|
|
#1
|
|||
|
|||
Another Tumbler Removal Question
Car: 89 260E W124
Read numerous articles in archive. My self made 2mm thick tool will not get inside the two slots. The barrel sleeve is blocking the way. I know I need the 2mm thickness to release the tumbler. Pls. help, it is driving me nuts!!
__________________
joel Prayers bring forth enlightenment. |
#2
|
||||
|
||||
You mean the 2mm wire won't fit in the holes?
I had good luck with a single strand of 12 guage copper wire extracted from Romex household electric wire. I used the unsheathed ground wire. It was a very tight fit, but it worked. BTW, the 14 guage was too narrow. Good luck. Jeff Pierce
__________________
Jeff Pierce Current Vehicles: '92 Mercedes 190E/2.3 (247K miles/my daily driver) '93 Volvo 940 Turbo Wagon (263K miles/a family truckster with spunk) '99 Kawasaki Concours Gravely 8120 Previous Vehicles: '85 Jeep CJ-7 w/ Fisher plow (226K miles)'93 Volvo 940 Turbo Wagon '53 Willys-Overland Pickup '85 Honda 750F Interceptor '93 Nissan Quest '89 Toyota Camry Wagon '89 Dodge Raider '81 Honda CB 750F Super Sport '88 Toyota Celica '95 Toyota Tacoma '74 Honda CB 550F |
#3
|
||||
|
||||
copper hanger wire has served me well..be sure to cut the end @ a 45 degree angle.
Jonathan
__________________
Blue Ridge Mercedes Jonathan Hodgman http://www.blueridgemb.com/ Enthusiast Service, Restoration & Tuning. Follow Us on Facebook! Located in the Atlanta area Specializing in all pre and post merger AMG's including Hammers and DOHC M117 engines. Mercedes Repair Atlanta |
#4
|
|||
|
|||
You can easily remove the face plate surrounding the ignition lock. The black face plate between steering column and center of dash is a compression fit. Use thin blade (knief, screw ddriver) and pry it out. You can also start at the felt gasket above the steering column. Pull it out a little and insert tool.
Bob PS More info in my post 5-26-04 |
#5
|
|||
|
|||
thanks for the replies. i've been using a copper wire 14 gauge. will try again.
__________________
joel Prayers bring forth enlightenment. |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
1996 s320 ash tray removal question | fredsegal | Tech Help | 1 | 04-17-2005 09:58 AM |
Trunk Lock Tumbler Removal? | 300EVIL | Tech Help | 5 | 06-28-2003 11:40 PM |
Tumbler question | ned2683 | Tech Help | 2 | 03-02-2003 07:20 PM |
Tumbler question | ned2683 | Diesel Discussion | 8 | 03-01-2003 04:42 PM |
Help me Mr. Wizard! Tumbler | glenmore | Tech Help | 3 | 10-02-2002 01:33 AM |