|
|
|
|
|
|
|
#1
12-12-2005, 12:42 PM
|
|||
|
|||
|
Removing Power Steering Pump
I need help!!! I am trying to take the PS pump off of my 1988 300E and rebuild it. I have gotten the top 2 screw out but can not get the pump out. I believe there is a screw behind the pulley. Any help on how to get this off would be greatly appreciated. I need to get it off because I have other things taken apart as well and also need to get to the belt tensioner to replace it. Please help. Thanks Brandon
|
|
#2
12-12-2005, 08:12 PM
|
|||
|
|||
|
From memory, there should be two bolts on the bottom. One is a long bolt that runs through the PS pump mounting bracket, with the head on the front and a nut securing it on the back. There should also be a short bolt that secures it from behind. Four bolts in total (I think).
|
|
#3
12-12-2005, 08:45 PM
|
|||
|
|||
|
Quote:
__________________
-Marty 1986 300E 220,000 miles+ transmission impossible (Now waiting under a bridge in order to become one) Reading your M103 duty cycle: http://www.peachparts.com/shopforum/831799-post13.html http://www.peachparts.com/shopforum/831807-post14.html
|
|
#4
12-13-2005, 09:50 AM
|
|||
|
|||
|
Thanks for the replys. You were both right. There are four bolts and I had to remove the pulley to get the last one out. That was a fun job. I got it off and also pulled the belt tesioner off to replace that. I just hope it is as much fun to put back on on as it was to take off. Thanks, Brandon
|
 |
| Bookmarks |
|
|
Hybrid Mode
