|
|
|
|
|
#1
03-19-2001, 04:10 PM
|
||||
|
||||
|
I found a leak in the back of the block near the firewall in the driver's side. It is the heater return hose. Very obvious. I tried to readjust the clamps but, I do not know if that is going to be a permanent fix. My question is: Is there an "O" ring or some kind of seal on that end or, is it just the hose? Any tips?
__________________
J.H. '86 300E 
|
|
#2
03-19-2001, 08:27 PM
|
|||
|
|||
|
I have seen many of the hoses pin-hole and leak.
Also, there is an o-ring on the connector going into the head.
__________________
Benzmac: Donnie Drummonds ASE CERTIFIED MASTER AUTO TECHNICIAN MERCEDES SPECIALIST 11 YRS
|
 |
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Block heater! - Not the usual story.... | Breckman99 | Off-Topic Discussion | 8 | 01-20-2005 11:33 PM |
| 67 Fintail Heater hose diagram/setup | burningman | Vintage Mercedes Forum | 3 | 10-27-2004 05:37 PM |
| 79 300SD: replacing "skinny banana" rubber fuel hose | sgrist | Diesel Discussion | 9 | 12-23-2003 12:26 PM |
| diesel return hose | MikeL | Diesel Discussion | 4 | 10-14-2003 01:04 AM |
| Coolant leak from one of the hoses | elau | Tech Help | 2 | 12-12-2001 11:47 AM |
Linear Mode
