|
|
|
|
|
#1
04-23-2001, 09:53 AM
|
||||
|
||||
|
On my 300D the compressor system works by putting 12 v to the pressure switch circuit. I have been doing some troubleshooting and have found that I am not getting power through this circuit. Has anyone got a schematic that shows where the power is supplied from that they could fax to me? Should one side of the evap temp sensor have power (the black/red wire maybe)? Does the pushbutton console supply the 12 volt power for this circuit? The schematic I have does not go into enough detail to indicate where this circuit "ends". It just shows one end which is at the Klima relay. I am running a new Klima relay.
thanks, Jim '85 300D '95 E320 '97 CRV 
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 1985 300D FOR SALE (not mine) | Aaron | Mercedes-Benz Cars For Sale | 1 | 05-10-2004 02:26 PM |
| 300D A/C Evaporator Replacement | Shep | Diesel Discussion | 11 | 02-29-2004 09:05 PM |
| 1985 300D Terrible Rotten Eggs smell from HVAC system? | Carrameow | Diesel Discussion | 0 | 04-27-2003 11:30 PM |
| '85 300D A/C question | zachv | Tech Help | 1 | 06-15-2002 02:09 PM |
| 300TE A/C Question | BENZ-LGB | Tech Help | 7 | 06-09-2002 10:13 AM |
Threaded Mode
