|
|
|
|
|
#1
05-02-2001, 08:45 AM
|
|||
|
|||
|
The compressor does not kick in. The belt is not slipping.
Is there a way to bypass the low pressure switch just to check if the compressor works and where is the location of this low/high pressure switch
__________________
SANDEEEP 89 300SEL 230,000Km 
|
|
#2
05-02-2001, 09:08 AM
|
|||
|
|||
|
On my 82 300D T the switch is in the front lower right corner of the engine compartment. The switch is mounted on a round device with that looks like a sight glass on the top. The switch has two spade connectors on it and if you disconnect them and connect them together the compressor might engage, if it does you are low on freon. Do not run the compressor long this way. I hope this helps.
Rick
|
|
#3
05-03-2001, 09:25 AM
|
|||
|
|||
|
Almost certainly the system is out of gass take it to your local AC dealer and get some pressure gauges on the system or go to Kaymart or Walmart and buy the kit to check it out and refill it yourself
__________________
Larry
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| W124 A/C Diagnostic | djankov | Diesel Discussion | 14 | 08-02-2004 11:14 AM |
| 1992 300E a/c not working | fish4stripers | Tech Help | 6 | 06-10-2004 01:33 PM |
| a/c not working | mr benz | Off-Topic Discussion | 1 | 05-28-2004 10:38 PM |
| Winters over and A/C season begins | pdxman | Diesel Discussion | 7 | 03-13-2004 01:38 PM |
Linear Mode
