Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help




Go Back   PeachParts Mercedes ShopForum > Technical Information and Support > Tech Help

Reply
 
LinkBack Thread Tools Display Modes
  #1  
Old 01-15-2007, 07:44 AM
shammy
 
Join Date: Jan 2007
Location: Rincon, Georgia
Posts: 7
Question 1991 190E 2.6 that will not start

Help needed,

Have a 1991 190E 2.6 that will not start. In the recent past there hav been a few times when I had to crank the car several times befor it would crank. Now it turns over but will not start.



I am getting good spark and fuel to the fuel distributor but I do not think any fuel is getting past this point. I removed a couple of the injector lines and no fuel is present.


Any suggestions?
Reply With Quote
  #2  
Old 01-15-2007, 11:06 AM
david s poole
 
Join Date: Mar 2005
Location: dallas
Posts: 1,822
check out the fuel pump relay behind the battery.there are two relays back there .the first is the a/c and the back one is the fuel pump.pull it out and use a pce of bare wire to join pins 30 and 87 and plug it back in.
__________________
David S Poole
European Performance
Dallas, TX
4696880422

"Fortune favors the prepared mind"
1987 Mercedes Benz 420SEL
1988 Mercedes Benz 300TE (With new evaporator)
2000 Mercedes Benz C280
Reply With Quote
  #3  
Old 01-15-2007, 03:17 PM
shammy
 
Join Date: Jan 2007
Location: Rincon, Georgia
Posts: 7
There were four units behind the battery. Two were rather large so I don't believe they were fuel pump relays. The third one was a MAS unit, the fourth one was a small relay with a 10 amp fuse on top and corresponding numbers that you were talking about. Problem is there is a number 30, a number 30 A, and also a 87 E, and 87L. Which two should I run the wire between? Thanks for any help you can give.
Reply With Quote
  #4  
Old 01-20-2007, 05:48 PM
shammy
 
Join Date: Jan 2007
Location: Rincon, Georgia
Posts: 7
Thank you David Poole for your help you were right on the money. The MAS control unit was bad. Now all I need to do is find a control unit at a fair price.Again thanks
Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are On
Pingbacks are On
Refbacks are On




All times are GMT -4. The time now is 06:16 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2011 Pelican Parts - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page