|
|
|
|
|
#1
08-09-2001, 05:05 PM
|
|||
|
|||
|
C43 Airbox Filter Change
I have the airbox off my car but I don't know if I need to use
a specific torx bit on the screws. I have a T15, T20, and T25 but they don't seem to get the correct bite. Am I using the right tool or is there some special size only manufactured by the MB elfs? Thanks Chas. 
|
|
#2
08-10-2001, 07:03 AM
|
|||
|
|||
|
I cant remember what size it is but they are not difficult to remove, they should come out relatively easy even if you can get close to the correct size. I just have a standard Craftsman torx bit set and had no trouble finding the correct size???
|
 |
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Hydraulic filter change on E320 Wagon? | slilley | Tech Help | 4 | 09-27-2021 07:02 PM |
| fuel filter change | Phil | Diesel Discussion | 73 | 10-08-2006 12:10 PM |
| ml/plug, fuel filter change | cerbomark | Tech Help | 5 | 01-30-2004 05:42 PM |
| oil filter change on 606 | slowmoe | Diesel Discussion | 8 | 08-02-2003 06:23 PM |
| C43 sparkplug / air filter change | Lonestar C43 | Tech Help | 4 | 03-07-2003 06:53 PM |
Linear Mode
