|
|
|
#1
|
||||
|
||||
How is fuel sending unit tested?
Car is a 1992 300 TE.
Sending unit is out of car. Terminals are G, W, and T. I have manual which says float down ohm reading should be 77.8 + or - 2.3 ohms. With float turned 180 degrees, i.e., float up should read 3.2 + or - .7 ohms. Question is which terminals are checked for each position? |
#2
|
|||
|
|||
G and W will be for Float resistance test.
W and T will be for Reserve lamp indicator switch..which will be open/closed continuity..........no ohms.
__________________
A Dalton |
#3
|
||||
|
||||
Thanks I'll check it tomorrow.
|
Bookmarks |
|
|