|
|
|
|
|
#1
02-15-2002, 02:00 PM
|
|||
|
|||
|
Quick question about Bosch Wire Set
UPS guy just dropped off my new plugs and wires, and upon inspecting the wires I noticed that 1 of the boots is different than the others.
Of the 7 wires in the box: 1 is for the coil there are 5 various lengthed with the SAME boots and 1 smaller Elbow boot. This is the one that I dont like. Its about the same length as the shortest "normal" booted wire. Also, the one in question has a 5k ohm resistor written on it, and the 5 others have 1k resistance. part numbers (5 boots): 0356301022 the other one: 0356351027 This is for a 1970 280 se/sl. Wire set part number : 09023 I just want to make sure nothing has accidentally been mixed up. Thanks a lot! 
|
|
#2
02-15-2002, 11:35 PM
|
|||
|
|||
|
btt? I'm hoping to make this my Sat morning project
|
 |
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| R12/R134a gauge set question | erubin | Tech Help | 6 | 07-22-2003 12:24 AM |
| Plug Question: Can a Bosch H9DC be used in a 2.3 8v? | haasman | Tech Help | 4 | 07-13-2003 09:50 PM |
| Quick question about verifying engine originality | justinbowser | Vintage Mercedes Forum | 10 | 06-23-2003 08:22 PM |
| Question about Bosch FI training videos | Mike Murrell | Tech Help | 0 | 01-09-2003 12:46 AM |
| Plug Wire Question | Mr. BILL | Tech Help | 4 | 01-14-2001 09:55 AM |
Linear Mode
