|
|
|
|
|
#2
10-06-2012, 12:25 AM
|
|||
|
|||
|
Your transmission should not move by hand....
__________________
http://i193.photobucket.com/albums/z...-RESIZED-1.jpg 1991 300E - 212K and rising fast... 
|
|
#3
10-06-2012, 10:40 AM
|
||||
|
||||
|
How much movement are you talking about??
The driveshaft, not any harder than any other 210 chassis. You need a new flex disc or what? If you can support the trans and remove the crossmember it becomes much easier to do the flexdisc, then you could do the rear mount if you need to.
__________________
Click here to see a photo album of my '62 Sprite Project Moneypit (Now Sold)
|
|
#5
10-06-2012, 04:15 PM
|
||||
|
||||
|
Could be either one. You will feel a lot of backlash going from drive to reverse if it's the flexdisc
__________________
Click here to see a photo album of my '62 Sprite Project Moneypit (Now Sold)
|
|
#7
10-08-2012, 08:36 AM
|
||||
|
||||
|
Could be worn engine mounts. How many miles on them?
__________________
Prost! 
|
|
#9
10-08-2012, 02:04 PM
|
|||
|
|||
|
As far as engine mounts....try moving your engine by hand, it shouldn't move. When mine were bad, I could push the engine around quite easily...
__________________
http://i193.photobucket.com/albums/z...-RESIZED-1.jpg 1991 300E - 212K and rising fast...
|
 |
| Bookmarks |
|
|
1997 e-420 driveline
Linear Mode
