|
|
|
#1
|
|||
|
|||
How do you test camshaft position sensor for a 91 560SEL?
Is there a way to test (Resistance or voltage) to verify that the camshaft position sensor is working properly? i am trying to rule it out as the cause of a rough idling at start up. I did clean the sensor and traced back the wiring to the test port ( i believe the X1 test port). However, the wires from the senor is just terminated to the test port without any connection to anything. what am I missing?
|
#2
|
|||
|
|||
Namely that a 91 560 SEL doesn't have a cam position sensor.
There is a crank position sensor but it will not be the fix you are looking for.
__________________
90 300TE 4-M Turbo 103, T3/T04E 50 trim T04B cover .60 AR Stage 3 turbine .63 AR A2W I/C, 40 LB/HR MS2E, 60-2 Direct Coil Control 3" Exh, AEM W/B O2 Underdrive Alt. and P/S Pulleys, Vented Rear Discs, .034 Booster. 3.07 diffs 1st Gear Start 90 300CE 104.980 Milled & ported head, 10.3:1 compression 197° intake cam w/20° advancer Tuned CIS ECU 4° ignition advance PCS TCM2000, built 722.6 600W networked suction fan Sportline sway bars V8 rear subframe, Quaife ATB 3.06 diff |
#3
|
|||
|
|||
Quote:
I know the crank position sensor is installed at the back of the engine. |
#4
|
|||
|
|||
Diagnostic sensor, nothing more.
__________________
90 300TE 4-M Turbo 103, T3/T04E 50 trim T04B cover .60 AR Stage 3 turbine .63 AR A2W I/C, 40 LB/HR MS2E, 60-2 Direct Coil Control 3" Exh, AEM W/B O2 Underdrive Alt. and P/S Pulleys, Vented Rear Discs, .034 Booster. 3.07 diffs 1st Gear Start 90 300CE 104.980 Milled & ported head, 10.3:1 compression 197° intake cam w/20° advancer Tuned CIS ECU 4° ignition advance PCS TCM2000, built 722.6 600W networked suction fan Sportline sway bars V8 rear subframe, Quaife ATB 3.06 diff |
#5
|
|||
|
|||
that's what I thought. Thank you for the confirmation
|
Bookmarks |
|
|