|
|
|
|
|
#1
06-30-2002, 09:10 PM
|
||||
|
||||
|
Replacing tie rods
I have a small hydrolic jack and two jack stands,where is the best place to put the jack stands to get the front end completly off the ground safely? [89 420sel] Is it a good idia to remove both front wheels?
|
|
#2
06-30-2002, 10:18 PM
|
||||
|
||||
|
420,
Jack the car up by the factory jacking points just behind the front wheels. Get the car safely on the jack stands to secure the vehicle since you will likely have to do some hammering to remove the old tie rods. Removing the wheels is not necessary, but may help in accessability. Good luck,
__________________
Brandon 2008 S550 1957 Dodge D100 1967 VW Microbus 21 Window 2001 Suburban 2004 Beach cruiser bicycle -----------------GO DUKE!----------------- "It cannot be emphasized too strongly or too often that this great nation was founded not by religionists, but by Christians; not on religion, but on the Gospel of Jesus Christ. For that reason alone, people of other faiths have been afforded freedom of worship here." Patrick Henry 1776
|
 |
| Bookmarks |
|
|
Linear Mode
