|
|
|
#1
|
|||
|
|||
At last my engine runs (very fast)----MB doc suggested(06-09-99)---"that the cold start relay could be stuck --unplug cold start valve and see if engine runs any better---also the vacuum hose for the m.a.p sensor could leak"---QUESTION would like to check that first before resetting tick over---where are they located------------------------------ I feel I have to check every thing on this engine timing dwell valves compressions etc---trying to locate timing marks ---looking around main crankshaft area in engine front so far have not seen them (lot of belts in this area) QUESTION am I looking in right place------------------------------------------would like to use a remote starter switch but dont want to cause any damage QUESTION where would be the best place to fix this and having started engine what is the best way to stop the engine from under the hood
------------------ syd 81.300SD.196k 72.300SEL 4.5 mileage.Only god knows! |
#2
|
|||
|
|||
Map sensor is big silver thing with hose and wire on it on the fender. The timing marks are on the front balancer and the pin is on the bottom of the water pump. You will need a flash light to see them.
------------------ Benzmac: ASE CERTIFIED MASTER AUTO TECHNICIAN SHOP MANAGER FOR 14 BAY FACILITY MERCEDES SPECIALIST 8 YRS PARTNER IN MERCEDESSHOP.COM |
#3
|
|||
|
|||
thanks ---could you help me with the cold start valve location---syd
|
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Ignition timing resistor located on W202!!! | Koolvin | Mercedes-Benz Performance Paddock | 2 | 01-12-2003 03:59 PM |
timing 4.5 sel | robertbrown29 | Tech Help | 3 | 08-10-2002 10:33 PM |
Ignition timing | jundat | Vintage Mercedes Forum | 1 | 06-21-2002 03:51 AM |
Ignition timing for the M/B 560 SEC. | lennyjay | Tech Help | 3 | 05-17-2002 02:10 PM |
Ignition Timing | Tom16v | Tech Help | 1 | 01-21-2000 08:26 PM |