|
|
|
#1
|
||||
|
||||
What torque setting to use for oil pan
Does anyone know what torque setting to use on hex bolts that hold the oil pan for a ’95 E420?
__________________
Joe95E420 |
#2
|
|||
|
|||
oil sump to block
m6 9nm m8 21nm m10 40 nm this is for the main pan, as in the alloy one, not the steel sub pan. Joe
__________________
Project Smoker, '87 603 powered wagon Hauler, 96 CTD can you say torque? Toy 73 Cougar xr7 convertible Acme Automotive Inc. Raleigh NC 919-881-0364 |
#3
|
||||
|
||||
I am installing the lower oil pan
The pan that has the oil drain plug. Will torque numbers you listed be any different?
One other question while we are on this subject, I was told by the local dealer parts man that it would be wise to use silicon on the gasket for better sealing. Any advise on that? Like what type/brand of silicon? Do I apply thin coat to both sides of the gasket or just the pan side? Thanks
__________________
Joe95E420 |
Bookmarks |
|
|