|
|
|
#1
|
||||
|
||||
how difficult to replace...
How difficult is it to replace the inside door handle latch on my '90 350SDL? The handle that you pull to open up the door. I believe it is held in place via a pin at the hinged point. I think the pin is broken somewhat because I can grab it and it wiggles up and down. Do I have to take the whole door panel off? If so, how difficult is it? It is a W126.
Thanks fellas.
__________________
Frank 84 500SEL EURO 101K ( JUST LIKE MY 1ST WIFE. GLAD TO GET RID OF HER! ) 85 300D 310K (sold) 90 350SDL 184K sold 83 300D 118K (sold) 88 300E 153k (sold) 93 400E 105K (sold) |
#2
|
|||
|
|||
door handle
The inside door handles are the same on 126's and 123's. Carefully pry out the plastic liner beneath the release handle(easier than it sounds). This will reveal a phillips screw holding the handle in place. Remove the screw and manipulate the handle to release it from the rod connecting it to the door lock and you are 1/2 way there. Install the new handle in reverse order. You should have no problem
|
Bookmarks |
|
|