Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help




Go Back   PeachParts Mercedes ShopForum > Technical Information and Support > Tech Help

Reply
 
LinkBack Thread Tools Display Modes
  #1  
Old 08-31-2003, 02:34 PM
AMH AMH is offline
Virginia Gentleman
 
Join Date: Jun 2003
Posts: 219
Subframe Mounts 123 PROBLEM SOLVED!!!!!

When I replaced the subframe bushings, they would not seat completely, and there was a gap of approx. 1/8 inch between the mount and subframe. I figured they would settle in over a few day's time, and require re-torquing.
The driveshaft/differential geometry was altered with new mounts, adding this gap only aggravated the situation. I removed each mount bracket, placed a block of wood between the subframe and body, and centered a jackstand under each mount.
The weight of the car did the rest. A floor jack was under the differential, for two reasons. Not to place excessive stress on the mounts, and help support the car as jackstands on rubber mounts is a tricky situation.
The block of wood, suggested by a post in the archives keeps the subframe mount sleeve away from the sleeve protruding out of the body.
The noise is gone, the car handles as it should, and now it's time for the front end rebuild so I can return Rusty's spring compressor.
Alan
Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are On
Pingbacks are On
Refbacks are On




All times are GMT -4. The time now is 07:59 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2011 Pelican Parts - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page