|
|
|
#1
|
||||
|
||||
Got some minor surface rust under front door seals..('92 400e)..Along the top of the doors. What's the trick to removing the old rubber and installing new seals? The current seals seem to very in-place with adhesive....Planning on removing seals so I can put a halt the rust .Your help is appreciated
|
#2
|
|||
|
|||
I don't remeber for certain, but I think that they are pushed into a groove. I think that you lube them up and then slide into place. If glue is needed, you can use the 3M super weatherstrip adhesive. It will hold.
------------------ Benzmac: Donnie Drummonds 1992 500E (very soon I hope 1981 280GE SWB ASE CERTIFIED MASTER AUTO TECHNICIAN SERVICE MANAGER FOR 14 BAY FACILITY MERCEDES SPECIALIST 8 YRS PARTNER IN MERCEDESSHOP.COM |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
bad front differential? | jfhWY | Tech Help | 4 | 02-28-2003 01:39 PM |
Rear end low & front end high. Advise needed | mikaelw2001 | Tech Help | 1 | 02-12-2003 04:37 PM |
C43 - outside front tire wear revisited | jhuang | Mercedes-Benz Performance Paddock | 0 | 01-30-2003 10:23 AM |
front pump seal on W126 transmission | RKreutzer | Tech Help | 13 | 01-11-2003 09:56 AM |
Front Suspension Questions on W123 | r90skirk | Diesel Discussion | 4 | 01-23-2002 12:56 AM |