![]() |
|
|
|
#1
|
|||
|
|||
My beloved 83 300 td wagon has started to shake wildely after warming up. When it's cold, no problems. The car has 152k miles and gets regular service. The car runs w/no problems when the idle is raised.
help! fuel injector problem? vacuum problem? all suggestions are welcome. I really love this car! thanks, Andrew |
#2
|
|||
|
|||
II have the same problem look at benzman5000 shakes at start up they said a disrtbutor or fuel injector you can find the distributer under do it your self
|
#3
|
|||
|
|||
Andrew,
Do a search for Rack Bolt. I changed mine, and made a WORLD of difference. You need to have the engine hot to change it and get it adjusted correctly, so be prepared to spend a little while sweating over the engine compartment. I purchased mine for $23. An updated version came out in 1985, and it cures most of that shaking. Mine got so bad that people would stare at me at stoplights, and you couldn't carry on a conversation without your voice sounding like Catherine Hepburn. ![]() Good Luck!! ------------------ R Talley 84 300D-T |
#4
|
|||
|
|||
Have the compression checked! My '84 300D began to start hard, smoke alot, and sh-sh-sh-shake at idle. I spent time and money on the idle rack dampening srew, fuel filters, start of delivery timing adjustment, injectors, etc. before I threw up my hands in frustration and took it in for a compression check. The #3 cylinder made less than 200psi. One valve job later and I was back in business. The valve guides were worn on cyl. #3, preventing the valves from seating properly. I was told that even at 200K miles, there isn't much call for valve work on these motors, and I wouldn't jump to tearing off the head without the recommendation of a trusted and qualified mechanic, but the symptoms sound familiar.
|
#5
|
|||
|
|||
Thanks for everything!!
I tried adjusting the rack bolt..NG I searched on rack bolt and found a reply informing the owner of the vehicle to check the idle of the engine. I found by pushing on the engine "Stop" lever the engine smoothed out completely. I got my trusty manual out and found the idle adjustment screw, backed out the lock nut, made the adjustment, retightened the lock nut, and she is so smmmoooooth again!!! ![]() Now.. how do I increase turbo boost? MORE POWER...I NEED MORE POWER! THANKS AGAIN, ANDREW ------------------ |
![]() |
Bookmarks |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
1982 300TD R134a conversion with parallel flow condensor update!! | dmorrison | Diesel Discussion | 66 | 07-28-2012 10:38 PM |
300TD Hot Idle Shaking - apparently solved | surfblau | Diesel Discussion | 56 | 06-01-2009 05:41 PM |
300TD Rear Suspension | Swampy | Diesel Discussion | 56 | 05-02-2007 09:33 AM |
Questions about cylinder head/head gasket replacement on a 1987 300TD? | swogee | Diesel Discussion | 7 | 06-09-2004 09:15 AM |
bad shaking 300TD all the time now? Advice? | surfblau | Tech Help | 14 | 08-03-2002 11:20 PM |