|
|
|
|
|
#1
10-13-2000, 10:44 AM
|
|||
|
|||
|
I hv problem to restart my 280SE after the enginer is running for sometime or when it's hot. I need to repeat to start the car for at least 3 times without depressing the gas pedal in order to start the engine. Cold start no problem, just once start gets the engine start going. Would you advise what are the problems ? I understand from friends this is common problem for all the 280 models, is that right ? 
|
|
#2
10-14-2000, 05:31 AM
|
|||
|
|||
|
Have the fuel system pressures tested. If it's not holding "rest" pressure it will cause a hot start problem. It could be the fuel pump check valve,fuel accumulator, or the fuel distributor. Have a CIS System test done...if the shop you use dosn't know what that is, leave.
Randy D. ------------------ W.R.Durrance ASE Master Tech Mercedes Tech 21 Years 68 250SE 68 SAAB 96 Ice Racer 69 300SEL 6.3 70 300SEL 3.5 81 300TDT W.R.Durrance Engineering
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| hot start problem S500 m119 | jchowe420 | Tech Help | 1 | 10-25-2004 05:52 AM |
| '96 E300D, weird diesel engine problem | jarvisto | Tech Help | 0 | 06-25-2004 01:21 AM |
| O2 sensor | jchip | Tech Help | 9 | 03-22-2003 01:36 PM |
| 280SE 4.5 Hot Start Problem | MikeM | Tech Help | 3 | 01-04-2000 08:27 PM |
| Problem starting engine after overhaul | Stephan | Tech Help | 3 | 04-23-1999 08:32 PM |
Linear Mode
